Designed For:
- Medium to heavy weight doors for on or off-highway applications
- Door thicknesses of 1-7/8" or greater (47.6mm)
- Door weights of 50-200 lbs (23-91 kg)
- Door seal pressures of 50-150 lbs (23-68 kg) (suggested for best results)
- Applications where it is desireable to provide additional support to the trip lever
Material:
- Internal latch components: heat treated, smooth edge stamped steel
- Case halves: high strength steel
- Springs: non-corrosive stainless steel
Finish:
- Zinc plated, yellow chromate steel components
Internal Lubrication:
- Oven-cured dry lubricant is applied at factory all critical moving parts
|
|
|
Use With:
Installation:
- Four M6 X 1 grade 8.8-type fasterners are required (not included). Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs (13.3 N-m)
- Fastener mounting hole diameter should not exceed .281" (7.1mm)
Two position, double rotor latches comply with FMVSS 206 in primary and secondary latching positions when tested with approved TriMark FMVSS 206 compliant striker bolts in accordance with SAE J839. |
|