050-0110 Two-Rotor 1-Position Latch

Designed For:

• Medium to heavy weight storage, compartment and access doors for on or off-highway applications
• Door thicknesses of 1-7/8" or greater (47.6mm)
• Door weights of 50-200 lbs (23-91kg)
• Door seal pressures of 50-150 lbs (23-68kg) (suggested for best results)
• Applications where it is desireable to have a single position rotary latch

Material:

• Internal latch components: heat treated, smooth edge stamped steel
• Case halves: high strength steel
• Springs: non-corrosive stainless steel springs

Finish:

• Zinc plated, yellow chromate steel components

Installation:

• Four M6 X 1 grade 8.8-type fasterners are required (not included). Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs (13.3 N-m)
• Fastener mounting hole diameter should not exceed .281" (7.1mm)

Use With:

• TriMark 030-0200 Paddle Handle
  • 11328-03
  • 11330-02
• TriMark 030-0250 Paddle Handle With Inside Release Lever
  • 12219-12
  • 12220-12
• TriMark 030-0400 Paddle Handle
  • 13438-04
  • 11744-02
• TriMark 030-0450 2-Point Paddle Handle
  • 11812-37
  • 11813-37
• TriMark 070-0200 .675" Diameter Striker Bolt
  • 11111-16
  • 81623-16
  • 11737-16
  • 14270-01
  • 15506-01
  • 16912-01
• TriMark 090-0100 Rod Clips
  • 80801
  • 80802

Internal Lubrication:

• Oven-cured dry lubricant is applied at factory on all critical moving parts

CAUTION: Single-position, double rotor latches do not comply with FMVSS 206 requirements

.

.