050-0200 Slimline Rotary Latch

Designed For:

• Thinner, light or medium weight door applications
• Door weights up to 75 lbs. (34kg)
• Door seal pressures of 20-25 lbs. (9-11kg) recommended for best results (not to exceed 50 lbs - 23kg)
• Visible surface or concealed installation

Finish:

• Zinc plated, yellow chromate steel components
• Stainless steel

Material:

• Internal latch components: heat treated, smooth edge stamped steel
• Case halves: high strength steel
• Springs: non-corrosive stainless steel

Installation:

• Three M6 X 1 class 8.8 or better fasteners are recommended
• Vertical mounting with support ramp at top is required for proper alignment and subsequent engagement of locking pawl and striker bolt
• Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs. (13.3 N-m)

Use With:

• TriMark 030-0200 Paddle Handle
  • 11328-03
  • 11330-02
• TriMark 030-0250 Paddle Handle With Inside Release Lever
  • 12219-12
  • 12220-12
• TriMark 030-0400 Paddle Handle
  • 13438-04
  • 11744-02
• TriMark 030-0450 2-Point Paddle Handle
  • 11812-37
  • 11813-37
• TriMark 030-1100 2-Point Paddle Handle
  • 12395-05
• TriMark 040-0400 Push Button Center Control
  • 15992-01
• TriMark 070-0100 .500" Diameter Striker Bolt
  • 81687-16
  • 10335-16
• TriMark 090-0100 Rod Clips
  • 80801
  • 80802
• TriMark 100-0410 Cage Nut
  • 11920-16
  • 12111-16

Internal Lubrication:

• Oven-cured dry lubricant is applied at factory on all critical moving parts

Two position rotor latches comply with FMVSS 206 in primary and secondary latching positions when tested with approved TriMark striker bolts in accordance with SAE J839.