050-0210 Slimline Rotary Latch Single Position

Designed For:

• Thinner, light or medium weight storage, compartment and access door applications
• Door weights up to 75 lbs. (34 kg)
• Door seal pressures of 20-25 lbs. (9-11 kg) recommended for best results (not to exceed 50 lbs - 23 kg)
• Visible surface or concealed installation
• Applications where it is desireable to have a single position rotor latch

Material:

• Internal latch components: heat treated, smooth edge stamped steel
• Case halves: high strength steel
• Springs: non-corrosive stainless steel

Finish:

• Zinc plated, yellow chromate steel components
• Stainless steel

Installation:

• Three M6 X 1 class 8.8 or better fasteners are recommended
• Vertical mounting with support ramp at top is required for proper alignment and subsequent engagement of locking pawl and striker bolt
• Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs. (13.3 N-m)

Available:

• Left or right hand configurations
• With standard .267 (6.7mm) diameter "thru" axles or 1/4-20 UNC threaded axles (optional) or M6 X 1.0 threaded axles

Use With:

• TriMark 030-0200 Paddle Handle
  • 11328-03
  • 11330-02
• TriMark 030-0250 Paddle Handle With Inside Release Lever
  • 12219-12
  • 12220-12
• TriMark 030-0400 Paddle Handle
  • 13438-04
  • 11744-02
• TriMark 030-0450 2-Point paddle Handle
  • 11812-37
  • 11813-37
• TriMark 030-1100 2-Point Paddle Handle
  • 12395-05
• TriMark 040-0400 Push Button Center Control
  • 15992-01
• TriMark 070-0100 .500" Diameter Striker Bolt
  • 81687-16
  • 10335-16
• TriMark 090-0100 Rod Clips
  • 80801
  • 80802
• TriMark 100-0410 Cage Nut
  • 11920-16
  • 12111-16

Internal Lubrication:

• Oven-cured dry lubricant is applied at factory on all critical moving parts

CAUTION: Single position rotor latches do not comply with FMVSS 206 requirements