100-5010 TriGuard Heavy-Duty Door Hardware Module V1

This robust door hardware kit features modular construction that allows for simple customization, including remote or integrated exterior handle placement to accommodate variable door sizes. Designed for medium to heavy duty doors of 23-455kg (50-1000 lbs.) for entrance and rear door applications. The kit also allows for a minimum of assembly fasteners as well as providing a support system when adding significantly more weight to the door such as up-armoring existing doors.

This product has been discontinued and is being replaced by the 100-5020 TriGuard Heavy Duty Door Module V2. We do not recommend the use of this product in new applications. For additional information, please contact Customer Service at 1-800-447-0343.

Features/Benefits

Heavy duty modular construction is received fully assembled and tested

Cuts door assembly time by as much as 50% to 70% - improving vehicle cost and throughput

Improved serviceability in the field and ability to retrofit into existing applications

Interior locking mechanism provides additional safety for occupants

Single motion egress

Integrated weight support system

Incorporates TriMark’s proven 050-0850 Heavy Duty Latch

Available

Remote or integrated exterior handle options (remote version shown)

Right or left hand versions

Customization features available. Please inquire:

Mounting details

Length of grab bar

Exterior handle location

Material

Standard - high strength steel construction

Available with advanced lightweight aluminum alloy

Finish

Standard low gloss black powder coated

Mil-Spec soft grip nylon coated handle

1000 hour corrosion protection

Optional finishes available including: Black Magni coating, Tan/Olive CARC paint and Tan/Olive powder coating

Installation

Easy to install, mounts with (4) M10 X 1.75 fasteners and (3) M6 X 1.0 fasteners

Tighten to the manufacturers’ recommended torque value

Caution: Applications of this system may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards. These safety related requirements are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process latch, handle, lock mechanism, rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified within the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested in accordance with SAE J839 and that this system meets FMVSS 206 (ECE R11) loads and locking requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval.

Individual part dimensions are for reference only. Refer to individual part drawings for complete dimensions, specifications, and installation procedures. Engineering assistance and application drawings are available.

Typical Uses

Typical application use illustrations are organized by Industry/System and are intended to give the user some ideas for specifying a complete system using TriMark products.

Not all Industry/System applications have typical use illustrations. If a typical use illustration is not available for your specific application, please submit a technical product information request and a technical representative can assist you in selecting a product(s) solution for your specific application.