Designed For

• Medium to heavy weight doors for on or off-highway applications
• Door thicknesses of 1-7/8" or greater (47.6 mm)
• Door weights of 50-200 lbs. (23-91 kg)
• Door seal pressures of 50-150 lbs. (23-68 kg) (suggested for best results)
• Applications where it is desireable to provide additional support to the trip lever

Features/Benefits

• Allows for ± .060 (1.52mm) strike travel from .784 (19.91mm) locating dimension with the recommended .550 (13.9mm) diameter striker bolt (070-0201)
• Ideal for applications with high vibration loading and where controlled travel between the latch and strike is characteristic of the application

Available

• In left or right hand configurations (right hand shown)
• With (4) 1/4-20 UNC or M6 x 1 threaded axles or .286 diameter "thru" axles
• With trip lever options (please inquire)
• With a torsion return spring

Installation

• Four 1/4-20 UNC grade 5 or M6 x 1 class 8.8 or better fasteners are required (not included).
• Tighten to the fastener manufacturers' recommended torque value, however, do not exceed 120 in-lbs (13 N-m)
• Fastener mounting holes diameter should not exceed .281 (7.1 mm)

Finish

• Zinc plated, clear chromate steel components

Internal Lubrication

• Oven-cured dry lubricant is applied at factory on all critical moving parts
  

Striker Installation

• Install striker bolt in door frame
• Close door carefully and check for interference between head of striker bolt and latch components
• Add or remove shims under striker bolt washer as required (outside diameter of shim should be larger than outside diameter of striker bolt washer)
• Adjust striker bolt vertically so door is not guided upward or downward while being closed
• CHECK TO DETERMINE THAT BOTH SECONDARY AND PRIMARY LATCHING POSITIONS ARE USABLE
• Door should be latched but not "closed" in secondary position with respect to adjacent surfaces in primary position
• If both primary and secondary positions are not evident, readjust striker bolt
• After installation, check door alignment and door seal pressures

Caution: Applications of this latch may fall within the requirements of FMVSS 206 (ECE R11) and SAE J839 safety standards. These safety related requirements are dependent on door application, e.g. front and rear hinged doors, sliding doors, or hinged upward swinging doors. The entire door hardware system must be included in the design/analysis process: latch, handle, lock mechanism, cables/rods/linkages, fasteners, hinges, etc. This ensures compatibility of all components within the hardware system. If FMVSS 206 (ECE R11) is a requirement, then all of the components within the door system must comply with strength, inertia and locking requirements as specified within the Standard. Note that this product complies with FMVSS 206 (ECE R11) when tested with approved TriMark Striker Bolts in accordance with SAE J839 and that this product meets FMVSS 206 (ECE R11) load requirements and may be used in FMVSS 206 (ECE R11) applications pending TriMark application approval.